ISSUE 72

 Return to the BUILD


“Construction of the ‘sinister’ side of the Terminator T-800 Endoskeleton begins with the assembly of the left bicep muscle.”

 

Contents


Parts

Magazine

  • T-800 Assembly – Model Instructions
  • Sci-Fi Cinema Legends – Watchmen
  • Real World Science – A Lifeform Less Ordinary?

The First Parts for the Left Arm

Step 1

Slide the shaft of the Shaft for Arm Part through the smaller end of the Left Arm Part, as shown:

Step 2

Fit the Cap for Arm Part over the large end of the Left Arm Part, aligning the center hole with the screw hole in the end of the Shaft for Arm Part:

Step 3

Secure the Cap for Arm Part to the Shaft for Arm Part with one (1) PM 3×8 mm screw. The screw needs to go down inside the shaft:

Thoughts


After all the complexity and steps to build the foot sections, this issue was a piece of cake! All of these parts are metal.

Running Total of screws used so far: 219

Next Up


 Issue 73 – Shoulder Part/Joint, Shafts for Left Arm

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Building the 1:2 scale Terminator T-800 from Hachette Partworks