ISSUE 47

 Return to the BUILD


“This issue, we’ll assemble the connective frame that links the pelvis together.”

 

Contents


Parts

Materials: The Lower Panel of Pelvis is plastic, but the two Pelvic Frames are metal.

Magazine

  • T-800 Assembly – Model Instructions
  • Sci-Fi Cinema Legends – Demolition Man
  • Real World Science – Cryonics and Cryogenic Suspension

Build


Working on the Central Pelvic Frame

Step 1

Fit the Pelvic Frame over the Lower Panel of Pelvis, aligning the four posts as shown:

Step 2

Secure these together with four (4) PB 2×4 mm screws:

Step 3 

Fit the two rounded tabs of the Pelvic Frame (Rear Section) over these two posts of the Pelvic Frame:

Steps 4-5

Secure these together with two (2) PM 2×6 mm screws:

With these issue’s steps now complete, the base of our pelvis should look like this:

Thoughts


Another short issue, but an important one. This is the central section of the pelvis that will connect to the spine.

Next Up


 Issue 48 – Pelvic Frame, Pelvic Shield (Right)

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.