ISSUE 106

 Return to the BUILD


“Insert the circuit board into the back of the Terminator T-800 Endoskeleton’s head.”

 

Contents


Parts

Materials: The only part in this issue is electronic.

Magazine

  • T-800 Assembly – Model Instructions
  • Sci-Fi Cinema Legends – Bad Taste
  • Real World Science – Where the Grass is Greener

Install the Circuit Board

Step 1

Retrieve your T-800 endoskeleton and lay him face down. Position the Circuit Board on the plates in the back of the head, as shown:

Step 2

Secure the Circuit Board into place with two (2) 2×4 mm PM screws.

Do not over-tighten these screws – the Circuit Board could be damaged:

Thoughts


This was a super short issue! It also concludes this two-shipment building session of our T-800 endoskeleton! In the next issue, we will finish up the build of the Terminator and start on the display base.

Next Up


 Issue 107 – Back of Head, Magnets, Neck Connectors, Searchlight Housing/LED/Cable/Lens/Stand

2 thoughts on “ISSUE 106”

    1. Unfortunately, I had to ship my T800 over from the UK via Hachette and do not have any issues left over. You might try to contact Agora Models and see if you can get Issue 106 from them.

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.